Garage Door Spring Replacement in Frisco

If you heard a bang from the garage and the door will not lift, the spring broke. It is the most common garage door repair in Frisco and the one people are most often tempted to try themselves. Please do not.

A wide double garage door on a shingle-sided house

Call (945) 302-2051 Get a quote

How to tell it is the spring

Look above the door, on the inside, at the horizontal bar running across the top of the opening. Torsion springs are the tightly wound coils on that bar. A broken one has a visible gap, usually an inch or two, where the coil has separated. On older or smaller doors you may have extension springs instead: long springs running alongside the horizontal tracks near the ceiling, one on each side. A broken extension spring hangs loose or is lying on the floor, and should have a safety cable running through it. If it does not, that is worth fixing at the same visit.

Why the second spring matters

Double doors, which is most Frisco garages, usually carry two torsion springs. They share the load and they were wound on the same day. When one breaks, the other has done the same number of lifts and is near the end too. Replacing only the broken one saves a little now and costs a second visit later, usually within months. Most reputable companies quote the pair as standard.

Standard or high-cycle

What the rating means

Springs are rated in cycles, one cycle being one open and one close. A standard builder spring is commonly rated around ten thousand cycles. High-cycle springs, made from heavier wire, are rated at twenty-five thousand or more.

Doing the arithmetic for your house

Count how many times the door runs on a normal day. A household that uses the garage as its front door, with two drivers, school runs and a teenager, can easily reach six or eight cycles a day. At that rate a ten-thousand-cycle spring lasts under five years and a high-cycle spring lasts well over ten. For a door that is used lightly, standard springs are fine.

What it costs

High-cycle springs add to the price of the job, often something like a third more, depending on the company. On a busy household's door they usually pay for themselves by skipping one future service call.

Why springs go in a cold snap

Springs are steel kept under constant torque. Steel near the end of its fatigue life is more likely to fail when it is cold, and a door that has been sitting overnight in a freezing garage starts its first lift of the morning at its stiffest. North Texas winters are short but sharp; after the February 2021 freeze, when DFW reached minus two, a lot of springs in this area failed in the same week. The monthly search data for this trade in Frisco runs highest in January and February, which fits.

Why this is not a DIY job

Winding a torsion spring means inserting steel bars into a cone and turning it, a quarter turn at a time, against a spring that wants to unwind. On a double door that is upwards of thirty quarter turns per spring. If a bar slips or the wrong size of bar is used, it spins with enough force to break bones, and set screws tightened wrongly let go later. Spring work is the one garage door job where professional equipment and experience are a matter of safety rather than finish.

If the door is stuck shut with a car inside, say so when you call. A broken spring is usually a same-day or next-morning visit.

Call (945) 302-2051 Send the details

What a proper spring job includes

Both springs replaced and sized to the door's actual weight, cables inspected and replaced if frayed, the door balanced so it stays put when lifted halfway by hand, rollers and hinges checked and lubricated, and the opener's force and travel settings re-checked, because a door that is properly balanced again needs much less force from the opener than one that has been limping on a weak spring. If the visit ends without the balance test, ask for it.

Common questions

How much is garage door spring replacement in Frisco?

Commonly around $350 to $750 for a pair of standard torsion springs on a double door, installed. High-cycle springs, oversized or very heavy doors, and new cables or rollers added at the same visit move it up.

Can I replace just the broken spring?

You can ask to, but on a two-spring door the other one has done the same work. Most people who replace one end up paying for a second visit within the year.

How long do garage door springs last?

Standard springs are commonly rated around ten thousand cycles. At four or five uses a day, that is six to eight years. High-cycle springs rated at twenty-five thousand or more last two to three times as long.

Can I still use the opener?

No. The opener is not built to lift the door by itself, and running it against a broken spring can strip its gear or bend the top panel.

Why did my spring break on a cold morning?

Steel at the end of its fatigue life tends to fail at its stiffest, and the first lift after a freezing night is the hardest one. The cold did not cause the wear; it picked the day.

Should I switch from extension springs to torsion springs?

On an older door that has extension springs, a conversion is common and gives a smoother, better-balanced door. It costs more than like-for-like extension springs. At minimum, extension springs should have safety cables running through them.

Also in Frisco

Also serving

Spring Replacement is available beyond Frisco, across Allen , Carrollton , Lewisville , McKinney and Little Elm .

Get a quote for spring replacement

Say what the door is doing and a local garage door company will call you back, usually the same or next working day. Answered Mon–Sat, 7am–7pm · after hours we call back first thing Or call (945) 302-2051 — most people get an answer faster that way.